因为警示带具有防水、防潮、耐磨、抗蚀、防静电等优点,可以用于普通水泥地面,比起地上划漆来说操作简单。那么您知道供水警示带应该怎样贴怎么撕合适呢?
Because the warning tape has the advantages of waterproof, moisture-proof, wear-resistant, anti-corrosion, anti-static and so on, it can be used on ordinary cement floors, which is simpler to operate than painting on the ground. Do you know how to paste and tear the water supply warning tape?
警示带应该怎样贴?
How should the warning tape be posted?
需要先检查贴地面警示带的地面是否干净,没有尘土或者油墨,不存在凹凸不平的坑等等。如果有发现,则应该先将这些地面用扫帚先清理干净,然后用清水将上面的飞尘以及油污清理干净,以免给地面警示带由于飞尘或油污带来起跷的现象。
It is necessary to check whether the ground with the ground warning tape is clean, free of dust or ink, uneven pits, etc. If you find anything, you should first clean up these floors with a broom, and then clean up the flying dust and oil dirt on them with clean water, so as to avoid the phenomenon of lifting the ground warning tape due to flying dust or oil dirt.
在贴地面警示带之前,则需要将地面辅设的区域规划好,用笔将地面警示带的位置定位好,在拉地面警示带的时候,应该沿着画好的线进行拉地面警示带,以免拉错位置,造成位置不能符合要求,带来不必要的麻烦以及材料上的浪费。
Before pasting the ground warning tape, it is necessary to plan the auxiliary area on the ground and locate the position of the ground warning tape with a pen. When pulling the ground warning tape, the ground warning tape should be pulled along the drawn line to avoid pulling the wrong position, causing the position to fail to meet the requirements, causing unnecessary trouble and waste of materials.
由于地面警示带自身有比较大的伸缩性,在拉地面警示带时,应该不能太过用力,容易造成地面警示带伸太长后,贴在地面上后,反弹,造成胶带贴不住。这样就造成材料的浪费,为了避免发生这样的情况,倍路捷小编建议大家在拉地面警示带的时候,应该用力适当。
Because the ground warning tape itself has relatively large flexibility, when pulling the ground warning tape, it should not be too hard, which is easy to cause the ground warning tape to stretch too long and rebound after sticking on the ground, causing the tape to fail to stick. This will cause waste of materials. In order to avoid such a situation, beilujie Xiaobian suggested that everyone should use appropriate force when pulling the ground warning tape.
How to tear the water supply warning tape stuck on the ground?
如果粘在地上的胶带可以用吹风机先在胶带表面吹一吹,然后就容易撕下来了。残留的可以用以下方法:
If the adhesive tape is stuck on the ground, you can use a blower to blow it on the surface of the adhesive tape first, and then it is easy to tear it off. Residual can be removed by the following methods:
1、用纸巾沾一些酒精(好用工业酒精,要不用医用的也凑合)擦拭,再蹭几下就干净了。
1. Wipe it with a paper towel dipped with some alcohol (it's easy to use industrial alcohol, and it's OK not to use medical alcohol), and then rub it a few times to clean it.
2、用丙酮。方法同上。用量少而且彻底,棒的是它能极迅速极容易地去掉这些残留的胶质,比洒精更好使。以上这两种都是溶剂,也是所有方法中,效果比较好的。
2. Use acetone. The method is the same as above. The dosage is small and thorough. The great thing is that it can remove these residual colloids very quickly and easily, which is better than sprinkling essence. The above two are solvents, which are also the best of all methods.
3、用洗甲水。用法也跟酒精丙酮一样。效果也很不错。洗甲水不要求质量,好的或一般的都行,只要能洗掉指甲油的通通可以。
3. Use nail polish remover. The usage is the same as alcohol acetone. The effect is also very good. Nail washing water does not require quality, good or ordinary, as long as it can wash away nail polish.
4、用护手霜。先把表面的印制品撕掉,然后再把护手霜挤一些在上面,慢慢地用大拇指搓,搓一会儿就能把粘的残胶都搓下来。就是慢一点儿。护手霜属于油脂类物质,其性质与胶类不相容。除胶就是用它这个特性。
4. Use hand cream. First tear off the printed products on the surface, then squeeze some hand cream on it, and slowly rub it with your thumb. After rubbing for a while, you can rub off the adhesive residue. Just slow down. Hand cream belongs to oil substances, and its properties are incompatible with gums. This feature is used to remove glue.
5、用香蕉水。就是用来油漆的一种工业用剂,也很容易就买到的(卖油漆的地方就有卖的)。方法也跟酒精丙酮一样。
5. Use banana water. It is an industrial agent used to remove paint, and it is also easy to buy (it is sold where the paint is sold). The method is the same as alcohol acetone.
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.binzhouhengtong.com And consult our staff, will serve you wholeheartedly.