1、地面标志

1. Ground signs

在地面相应位置上进行标记,埋设标志、标志砖、标志贴等。这种方式直观易找,但受地面环境限制,如在快速路上很难设置。遇道路维修或拆迁等情况,还会大量丢失标志。现阶段地面标记物均采用以上标志。

Mark the corresponding positions on the ground, bury signs, sign bricks, sign stickers, etc. This method is intuitive and easy to find, but it is limited by the ground environment, such as being difficult to set up on expressways. In case of road maintenance or demolition, a large number of signs will also be lost. At present, all ground markers use the above markings.

2、设备探测

2. Equipment detection

一旦地面标志丢失,就只好使用设备进行地下管道探测。对于金属管材,一般用金属探管仪(一种将电信号施加在管道上,然后追踪电信号走向的设备)进行路由定位。这种设备在地下管线少、无强磁、强电的地方效果较好,但对于管道密集的区域(如庭院)或导电性差的管道(如球墨铸铁管),探测效率会大打折扣。PE管根本不导电,因此无法采用此项技术。我们也试用了其他设备,如地磁成像仪、地下空腔探测仪等,但在霸州公司未进行实际应用，效果暂时无法确定。除此之外,据了解目前市场上还没有一种设备能在探测PE管时达到理想效果。

Once the ground signs are lost, equipment can only be used for underground pipeline detection. For metal pipes, a metal probe (a device that applies electrical signals to the pipeline and tracks the direction of the electrical signals) is generally used for routing and positioning. This type of equipment works well in areas with few underground pipelines, no strong magnetism, and strong electricity, but for areas with dense pipelines (such as courtyards) or pipelines with poor conductivity (such as ductile iron pipes), the detection efficiency will be greatly reduced. PE pipes are not conductive at all, so this technology cannot be used. We have also tried other devices, such as geomagnetic imagers and underground cavity detectors, but they have not been practically applied in Bazhou Company, and the effect cannot be determined temporarily. In addition, it is understood that there is currently no device on the market that can achieve ideal results in detecting PE pipes.

3、 金属薄膜示踪带

3. Metal thin film tracer band

在PE管道上方敷设金属薄膜示踪带,然后用探管仪进行探测。示踪带中的金属薄膜具有导电性,理论上可以体现出金属管的特性,但实际上由于金属薄膜的截面积太小,导电性不好,受周围金属管道干扰大,致使探测效果非常差,只有在干扰小且距离地面很近的地方才能被探测到。而且辐射过程中，每100米需进行一次连接，如连接不当，在后期使用过程中因土壤沉降会导致示踪带断裂，进而无法检测。

Lay a metal film tracer tape above the PE pipeline and then use a probe to detect it. The metal film in the tracer band has conductivity, which theoretically reflects the characteristics of the metal tube. However, in reality, due to the small cross-sectional area of the metal film, its conductivity is poor, and it is greatly affected by the interference of surrounding metal pipes, resulting in very poor detection effect. It can only be detected in areas with small interference and close to the ground. Moreover, during the radiation process, a connection needs to be made every 100 meters. If the connection is improper, the tracer band may break due to soil settlement during later use, making it impossible to detect.

4、 金属示踪线

4. Metal tracer line

为提高示踪物体的导电性,我们曾使用金属示踪线来替代金属薄膜示踪带。由于示踪线的线芯是铜,且具有一定的截面积,因此导电性明显好于薄膜示踪带,尤其在刚埋下去的时候,探测效果较好。但随着时间延长,示踪线暴露出很大问题。a.示踪线一旦有断点,如施工时被挖断自然锈蚀、连接时没接牢等,从断点往后就无法被探测到。b.相对于其他地下管道或线路,示踪线的导电性没有它们好,因此造成探测信号过于微弱,以于混淆管道位置。而且抗拉性能差，在定向钻穿越中无法敷设。

To improve the conductivity of tracer objects, we have used metal tracer lines instead of metal thin film tracer bands. Due to the fact that the core of the tracer wire is copper and has a certain cross-sectional area, its conductivity is significantly better than that of the thin film tracer tape, especially when it is just buried, the detection effect is better. But as time goes on, the tracer line exposes significant issues. a. Once there is a breakpoint in the tracer line, such as natural corrosion caused by excavation during construction, or loose connection during connection, it cannot be detected from the breakpoint onwards. b. Compared to other underground pipelines or lines, the conductivity of tracer lines is not as good as theirs, resulting in weak detection signals and confusion of pipeline positions. And the tensile performance is poor, making it impossible to lay in directional drilling crossing.

5、废旧通信光缆

5. Waste communication optical cables

鉴于金属示踪线的缺点，废旧通信光缆可以较好地该问题。通信光缆是由若干根（芯）光纤（一般从几芯到几千芯）构成的缆心和外护层所组成。光缆中有加强构件去承受外界的机械负荷，以保护光纤免受各种外机械力的影响，从而保证了光缆的耐久性。尤其在定向钻穿越施工中，光缆的强负荷力可以保证完整的敷设。在300500米间隔处，埋设检测桩，将光缆引检测桩内，方便日后检测定位。光缆的缺点是导电性能低于金属示踪线，受干扰的区域检测效果较差。

Given the drawbacks of metal tracer lines, waste communication optical cables can effectively solve this problem. A communication optical cable is composed of a core and an outer protective layer composed of several to several thousand core optical fibers. There are reinforced components in the optical cable to withstand external mechanical loads, in order to protect the optical cable from various external mechanical forces and ensure its durability. Especially in directional drilling crossing construction, the strong load capacity of optical cables can ensure complete laying. Bury inspection piles at intervals of 300 to 500 meters, and lead the optical cable into the inspection piles for convenient future detection and positioning. The disadvantage of optical cables is that their conductivity is lower than that of metal tracing lines, and the detection effect in disturbed areas is poor.

6、地下管道电子标志系统

6. Underground pipeline electronic marking system

其工作原理是将电子标志器埋设于管道上方,每个电子标志器内都存有一个的识别代码,如同每个人的身份证号码一样。电子标志器内可以自定义储存管道的重要信息,如相对位置、埋深、管径、管材、管道压力、敷设日期等。在地面上使用定位设备(探测仪)定位电子标志器的位置,并读取储存信息。

Its working principle is to bury the electronic marker above the pipeline, and each electronic marker has a unique identification code, just like the ID number of each person. The electronic marker can customize and store important information about pipelines, such as relative position, burial depth, pipe diameter, pipe material, pipeline pressure, laying date, etc. Use positioning devices (detectors) on the ground to locate the position of electronic markers and read stored information.

感谢您的阅读，此文的文章来源：燃气示踪线更多的内容和问题请点击：http://www.binzhouhengtong.com我们会继续努力的为您提供服务，感谢您的支持！

Thank you for reading. The source of this article is Gas Tracer Line. For more information and questions, please click: http://www.binzhouhengtong.com We will continue to work hard to provide you with services. Thank you for your support!